| 12345678910111213141516171819202122232425262728293031323334353637383940 |
- U-Boot for Wandboard
- --------------------
- This file contains information for the port of U-Boot to the Wandboard.
- Wandboard is a development board that has two variants: one version based
- on mx6 dual lite and another one based on mx6 solo.
- For more details about Wandboard, please refer to:
- http://www.wandboard.org/
- Building U-boot for Wandboard
- -----------------------------
- To build U-Boot for the Wandboard Dual Lite version:
- $ make wandboard_dl_config
- $ make
- To build U-Boot for the Wandboard Solo version:
- $ make wandboard_solo_config
- $ make
- Flashing U-boot into the SD card
- --------------------------------
- - After the 'make' command completes, the generated 'u-boot.imx' binary must be
- flashed into the SD card;
- $ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync
- (Note - the SD card node may vary, so adjust this as needed).
- - Insert the SD card into the slot located in the bottom of the board (same side
- as the mx6 processor)
- - Connect the serial cable to the host PC
- - Power up the board and U-boot messages will appear in the serial console.
|
