Minor cleanup for PCS440EP board

Patch by Stefan Roese, 13 Jun 2006

CHANGELOG

@@ -2,6 +2,9 @@
 Changes since U-Boot 1.1.4:
 ======================================================================
 
+* Minor cleanup for PCS440EP board
+  Patch by Stefan Roese, 13 Jun 2006
+
 * Add MCF5282 support (without preloader)
   relocate ichache_State to ram
   u-boot can run from internal flash

cpu/ppc4xx/spd_sdram.c

@@ -745,7 +745,7 @@ long int spd_sdram(void) {
 	 */
 	check_volt_type(dimm_populated, iic0_dimm_addr, num_dimm_banks);
 
-#if defined(CONFIG_440GX)
+#if defined(CONFIG_440GX) || defined(CONFIG_440EP) || defined(CONFIG_440GR) || defined(CONFIG_440SP)
 	/*
 	 * Soft-reset SDRAM controller.
 	 */

include/configs/pcs440ep.h

@@ -116,18 +116,17 @@
  *----------------------------------------------------------------------*/
 #define CONFIG_SPD_EEPROM               /* Use SPD EEPROM for setup             */
 #undef CONFIG_DDR_ECC			/* don't use ECC			*/
-#define SPD_EEPROM_ADDRESS      {0x50, 0x51}
+#define SPD_EEPROM_ADDRESS      {0x50}
 
 /*-----------------------------------------------------------------------
  * I2C
  *----------------------------------------------------------------------*/
 #define CONFIG_HARD_I2C		1	    /* I2C with hardware support	*/
 #undef	CONFIG_SOFT_I2C			    /* I2C bit-banged		*/
-#define CFG_I2C_SPEED		400000	/* I2C speed and slave address	*/
+#define CFG_I2C_SPEED		100000	/* I2C speed and slave address	*/
 #define CFG_I2C_SLAVE		0x7F
 
-#define CFG_I2C_MULTI_EEPROMS
-#define CFG_I2C_EEPROM_ADDR	(0xa8>>1)
+#define CFG_I2C_EEPROM_ADDR	(0xa4>>1)
 #define CFG_I2C_EEPROM_ADDR_LEN 1
 #define CFG_EEPROM_PAGE_WRITE_ENABLE
 #define CFG_EEPROM_PAGE_WRITE_BITS 3
@@ -211,6 +210,7 @@
 				CFG_CMD_ASKENV	| \
 				CFG_CMD_DHCP	| \
 				CFG_CMD_DIAG	| \
+				CFG_CMD_EEPROM	| \
 				CFG_CMD_ELF	| \
 				CFG_CMD_I2C	| \
 				CFG_CMD_IRQ	| \