|
|
@@ -11,6 +11,20 @@ Installation Instructions:
|
|
|
| X|
|
|
|
------
|
|
|
|
|
|
+ Put the s3 switch into the following position:
|
|
|
+
|
|
|
+ 1 0
|
|
|
+ ------
|
|
|
+ |x |
|
|
|
+ |x |
|
|
|
+ |x |
|
|
|
+ |x |
|
|
|
+ |x |
|
|
|
+ | x|
|
|
|
+ | x|
|
|
|
+ |x |
|
|
|
+ ------
|
|
|
+
|
|
|
2. Connect to the serial console and to the BDI. Power on. On the
|
|
|
serial line, you should see:
|
|
|
|
|
|
@@ -34,8 +48,17 @@ Installation Instructions:
|
|
|
|
|
|
prog 0xB0000000 <u-boot.bin> bin
|
|
|
|
|
|
-6. Power off. Restore the original S2 switch position. Power on.
|
|
|
- U-Boot should come up.
|
|
|
+6. Power off. Restore the original S2 switch position:
|
|
|
+
|
|
|
+ 1 0
|
|
|
+ ------
|
|
|
+ | x|
|
|
|
+ | x|
|
|
|
+ |x |
|
|
|
+ | X|
|
|
|
+ ------
|
|
|
+
|
|
|
+ Power on. U-Boot should come up.
|
|
|
|
|
|
|
|
|
|
|
|
@@ -48,5 +71,5 @@ can't really check whether 'erase' is complete by polling flash as it
|
|
|
is usually done. Instead, the flash driver simply waits for a given
|
|
|
time and assumes that erase then has passed. This behaviour is
|
|
|
identical to what the VxWorks driver does; also, the same timeout (6
|
|
|
-seconds) was chosen. Note that this timeout applies for each errase
|
|
|
+seconds) was chosen. Note that this timeout applies for each erase
|
|
|
operation, i. e. per erased sector.
|
wdenk