ppc4xx: Initialize magnetic couplers in PLU405

This patch fixes an ugly behavior of the IL712 magnetic couplers
as used on PLU405. These parts will remember their last state
over a power cycle which might cause unwanted behavior.

Signed-off-by: Matthias Fuchs <matthias.fuchs@esd.eu>
Signed-off-by: Stefan Roese <sr@denx.de>

board/esd/plu405/plu405.c

@@ -26,6 +26,7 @@
 #include <asm/io.h>
 #include <command.h>
 #include <malloc.h>
+#include <sja1000.h>
 
 #undef FPGA_DEBUG
 
@@ -61,6 +62,34 @@ au_image_t au_image[] = {
 
 int N_AU_IMAGES = (sizeof(au_image) / sizeof(au_image[0]));
 
+/*
+ * generate a short spike on the CAN tx line
+ * to bring the couplers in sync
+ */
+void init_coupler(u32 addr)
+{
+	struct sja1000_basic_s *ctrl = (struct sja1000_basic_s *)addr;
+
+	/* reset */
+	out_8(&ctrl->cr, CR_RR);
+
+	/* dominant */
+	out_8(&ctrl->btr0, 0x00); /* btr setup is required */
+	out_8(&ctrl->btr1, 0x14); /* we use 1Mbit/s */
+	out_8(&ctrl->oc, OC_TP1 | OC_TN1 | OC_POL1 |
+	      OC_TP0 | OC_TN0 | OC_POL0 | OC_MODE1);
+	out_8(&ctrl->cr, 0x00);
+
+	/* delay */
+	in_8(&ctrl->cr);
+	in_8(&ctrl->cr);
+	in_8(&ctrl->cr);
+	in_8(&ctrl->cr);
+
+	/* reset */
+	out_8(&ctrl->cr, CR_RR);
+}
+
 /* Prototypes */
 int gunzip(void *, int, unsigned char *, unsigned long *);
 
@@ -214,6 +243,13 @@ int misc_init_r(void)
 	out_8((void *)DUART1_BA + 1, fctr); /* write FCTR */
 	out_8((void *)DUART1_BA + 3, 0);    /* write LCR */
 
+	/*
+	 * Init magnetic couplers
+	 */
+	if (!getenv("noinitcoupler")) {
+		init_coupler(CAN0_BA);
+		init_coupler(CAN1_BA);
+	}
 	return 0;
 }
 

include/configs/PLU405.h

@@ -300,7 +300,8 @@
 /*
  * External Bus Controller (EBC) Setup
  */
-#define CAN_BA		0xF0000000	    /* CAN Base Address	        */
+#define CAN0_BA		0xF0000000	    /* CAN0 Base Address	*/
+#define CAN1_BA		0xF0000100	    /* CAN1 Base Address	*/
 #define DUART0_BA	0xF0000400	    /* DUART Base Address       */
 #define DUART1_BA	0xF0000408	    /* DUART Base Address       */
 #define RTC_BA		0xF0000500	    /* RTC Base Address         */