TQM5200: Call usb_cpu_init() during board init

usb_cpu_init() configures GPS USB pins, clocks, etc. and
is required for proper operation of kernel USB subsystem.
This setup was previously done in the kernel by the fixup
code which is being removed, thus low level init must be
done by U-boot now.

Signed-off-by: Marian Balakowicz <m8@semihalf.com>

board/tqm5200/tqm5200.c

@@ -441,15 +441,21 @@ ulong post_word_load (void)
 }
 #endif	/* CONFIG_POST || CONFIG_LOGBUFFER*/
 
-#ifdef CONFIG_PS2MULT
 #ifdef CONFIG_BOARD_EARLY_INIT_R
 int board_early_init_r (void)
 {
+#ifdef CONFIG_PS2MULT
 	ps2mult_early_init();
+#endif /* CONFIG_PS2MULT */
+
+#if defined(CONFIG_USB_OHCI_NEW) && defined(CFG_USB_OHCI_CPU_INIT)
+	/* Low level USB init, required for proper kernel operation */
+	usb_cpu_init();
+#endif
+
 	return (0);
 }
 #endif
-#endif /* CONFIG_PS2MULT */
 
 #ifdef CONFIG_FO300
 int silent_boot (void)