Blackfin: set proper LDRFLAGS for parallel booting LDRs

In order to boot an LDR out of parallel flash, the ldr utility needs a few
flags to tell it to generate the right header.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

board/bf533-ezkit/config.mk

@@ -1,4 +1,6 @@
 #
+# Copyright (c) 2005-2008 Analog Device Inc.
+#
 # (C) Copyright 2001
 # Wolfgang Denk, DENX Software Engineering, wd@denx.de.
 #
@@ -23,3 +25,7 @@
 
 # This is not actually used for Blackfin boards so do not change it
 #TEXT_BASE = do-not-use-me
+
+# Set some default LDR flags based on boot mode.
+LDR_FLAGS-BFIN_BOOT_PARA := --bits 16 --dma 8
+LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))

board/bf533-stamp/config.mk

@@ -1,4 +1,6 @@
 #
+# Copyright (c) 2005-2008 Analog Device Inc.
+#
 # (C) Copyright 2001
 # Wolfgang Denk, DENX Software Engineering, wd@denx.de.
 #
@@ -23,3 +25,7 @@
 
 # This is not actually used for Blackfin boards so do not change it
 #TEXT_BASE = do-not-use-me
+
+# Set some default LDR flags based on boot mode.
+LDR_FLAGS-BFIN_BOOT_PARA := --bits 16 --dma 8
+LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))

board/bf537-stamp/config.mk

@@ -1,4 +1,6 @@
 #
+# Copyright (c) 2005-2008 Analog Device Inc.
+#
 # (C) Copyright 2001
 # Wolfgang Denk, DENX Software Engineering, wd@denx.de.
 #
@@ -25,5 +27,6 @@
 #TEXT_BASE = do-not-use-me
 
 # Set some default LDR flags based on boot mode.
-LDR_FLAGS-BFIN_BOOT_UART       := --port g --gpio 6
+LDR_FLAGS-BFIN_BOOT_PARA := --bits 16 --dma 8
+LDR_FLAGS-BFIN_BOOT_UART := --port g --gpio 6
 LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))

board/bf561-ezkit/config.mk

@@ -1,4 +1,6 @@
 #
+# Copyright (c) 2005-2008 Analog Device Inc.
+#
 # (C) Copyright 2001
 # Wolfgang Denk, DENX Software Engineering, wd@denx.de.
 #
@@ -23,3 +25,7 @@
 
 # This is not actually used for Blackfin boards so do not change it
 #TEXT_BASE = do-not-use-me
+
+# Set some default LDR flags based on boot mode.
+LDR_FLAGS-BFIN_BOOT_PARA := --bits 16
+LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))