| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253 |
- # STK1000 customization
- if BOARD_ATSTK1002
- config BOARD_ATSTK1002_CUSTOM
- bool "Non-default STK-1002 jumper settings"
- help
- You will normally leave the jumpers on the CPU card at their
- default settings. If you need to use certain peripherals,
- you will need to change some of those jumpers.
- if BOARD_ATSTK1002_CUSTOM
- config BOARD_ATSTK1002_SW1_CUSTOM
- bool "SW1: use SSC1 (not SPI0)"
- help
- This also prevents using the external DAC as an audio interface,
- and means you can't initialize the on-board QVGA display.
- config BOARD_ATSTK1002_SW2_CUSTOM
- bool "SW2: use IRDA or TIMER0 (not UART-A, MMC/SD, and PS2-A)"
- help
- If you change this you'll want an updated boot loader putting
- the console on UART-C not UART-A.
- config BOARD_ATSTK1002_SW3_CUSTOM
- bool "SW3: use TIMER1 (not SSC0 and GCLK)"
- help
- This also prevents using the external DAC as an audio interface.
- config BOARD_ATSTK1002_SW4_CUSTOM
- bool "SW4: use ISI/Camera (not GPIOs, SPI1, and PS2-B)"
- help
- To use the camera interface you'll need a custom card (on the
- PCI-format connector) connect a video sensor.
- config BOARD_ATSTK1002_SW5_CUSTOM
- bool "SW5: use MACB1 (not LCDC)"
- config BOARD_ATSTK1002_SW6_CUSTOM
- bool "SW6: more GPIOs (not MACB0)"
- endif # custom
- config BOARD_ATSTK1002_SPI1
- bool "Configure SPI1 controller"
- depends on !BOARD_ATSTK1002_SW4_CUSTOM
- help
- All the signals for the second SPI controller are available on
- GPIO lines and accessed through the J1 jumper block. Say "y"
- here to configure that SPI controller.
- endif # stk 1002
|
