123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196197198199200201202203204205206207208209210211212213214215216217218219 |
- /*
- * arch/arm/mach-pxa/time.c
- *
- * Author: Nicolas Pitre
- * Created: Jun 15, 2001
- * Copyright: MontaVista Software Inc.
- *
- * This program is free software; you can redistribute it and/or modify
- * it under the terms of the GNU General Public License version 2 as
- * published by the Free Software Foundation.
- */
- #include <linux/kernel.h>
- #include <linux/init.h>
- #include <linux/delay.h>
- #include <linux/interrupt.h>
- #include <linux/time.h>
- #include <linux/signal.h>
- #include <linux/errno.h>
- #include <linux/sched.h>
- #include <linux/clocksource.h>
- #include <asm/system.h>
- #include <asm/hardware.h>
- #include <asm/io.h>
- #include <asm/leds.h>
- #include <asm/irq.h>
- #include <asm/mach/irq.h>
- #include <asm/mach/time.h>
- #include <asm/arch/pxa-regs.h>
- static inline unsigned long pxa_get_rtc_time(void)
- {
- return RCNR;
- }
- static int pxa_set_rtc(void)
- {
- unsigned long current_time = xtime.tv_sec;
- if (RTSR & RTSR_ALE) {
- /* make sure not to forward the clock over an alarm */
- unsigned long alarm = RTAR;
- if (current_time >= alarm && alarm >= RCNR)
- return -ERESTARTSYS;
- }
- RCNR = current_time;
- return 0;
- }
- #ifdef CONFIG_NO_IDLE_HZ
- static unsigned long initial_match;
- static int match_posponed;
- #endif
- static irqreturn_t
- pxa_timer_interrupt(int irq, void *dev_id)
- {
- int next_match;
- write_seqlock(&xtime_lock);
- #ifdef CONFIG_NO_IDLE_HZ
- if (match_posponed) {
- match_posponed = 0;
- OSMR0 = initial_match;
- }
- #endif
- /* Loop until we get ahead of the free running timer.
- * This ensures an exact clock tick count and time accuracy.
- * Since IRQs are disabled at this point, coherence between
- * lost_ticks(updated in do_timer()) and the match reg value is
- * ensured, hence we can use do_gettimeofday() from interrupt
- * handlers.
- *
- * HACK ALERT: it seems that the PXA timer regs aren't updated right
- * away in all cases when a write occurs. We therefore compare with
- * 8 instead of 0 in the while() condition below to avoid missing a
- * match if OSCR has already reached the next OSMR value.
- * Experience has shown that up to 6 ticks are needed to work around
- * this problem, but let's use 8 to be conservative. Note that this
- * affect things only when the timer IRQ has been delayed by nearly
- * exactly one tick period which should be a pretty rare event.
- */
- do {
- timer_tick();
- OSSR = OSSR_M0; /* Clear match on timer 0 */
- next_match = (OSMR0 += LATCH);
- } while( (signed long)(next_match - OSCR) <= 8 );
- write_sequnlock(&xtime_lock);
- return IRQ_HANDLED;
- }
- static struct irqaction pxa_timer_irq = {
- .name = "PXA Timer Tick",
- .flags = IRQF_DISABLED | IRQF_TIMER,
- .handler = pxa_timer_interrupt,
- };
- static cycle_t pxa_get_cycles(void)
- {
- return OSCR;
- }
- static struct clocksource clocksource_pxa = {
- .name = "pxa_timer",
- .rating = 200,
- .read = pxa_get_cycles,
- .mask = CLOCKSOURCE_MASK(32),
- .shift = 20,
- .is_continuous = 1,
- };
- static void __init pxa_timer_init(void)
- {
- struct timespec tv;
- unsigned long flags;
- set_rtc = pxa_set_rtc;
- tv.tv_nsec = 0;
- tv.tv_sec = pxa_get_rtc_time();
- do_settimeofday(&tv);
- OIER = 0; /* disable any timer interrupts */
- OSSR = 0xf; /* clear status on all timers */
- setup_irq(IRQ_OST0, &pxa_timer_irq);
- local_irq_save(flags);
- OIER = OIER_E0; /* enable match on timer 0 to cause interrupts */
- OSMR0 = OSCR + LATCH; /* set initial match */
- local_irq_restore(flags);
- /*
- * OSCR runs continuously on PXA and is not written to,
- * so we can use it as clock source directly.
- */
- clocksource_pxa.mult =
- clocksource_hz2mult(CLOCK_TICK_RATE, clocksource_pxa.shift);
- clocksource_register(&clocksource_pxa);
- }
- #ifdef CONFIG_NO_IDLE_HZ
- static int pxa_dyn_tick_enable_disable(void)
- {
- /* nothing to do */
- return 0;
- }
- static void pxa_dyn_tick_reprogram(unsigned long ticks)
- {
- if (ticks > 1) {
- initial_match = OSMR0;
- OSMR0 = initial_match + ticks * LATCH;
- match_posponed = 1;
- }
- }
- static irqreturn_t
- pxa_dyn_tick_handler(int irq, void *dev_id)
- {
- if (match_posponed) {
- match_posponed = 0;
- OSMR0 = initial_match;
- if ( (signed long)(initial_match - OSCR) <= 8 )
- return pxa_timer_interrupt(irq, dev_id);
- }
- return IRQ_NONE;
- }
- static struct dyn_tick_timer pxa_dyn_tick = {
- .enable = pxa_dyn_tick_enable_disable,
- .disable = pxa_dyn_tick_enable_disable,
- .reprogram = pxa_dyn_tick_reprogram,
- .handler = pxa_dyn_tick_handler,
- };
- #endif
- #ifdef CONFIG_PM
- static unsigned long osmr[4], oier;
- static void pxa_timer_suspend(void)
- {
- osmr[0] = OSMR0;
- osmr[1] = OSMR1;
- osmr[2] = OSMR2;
- osmr[3] = OSMR3;
- oier = OIER;
- }
- static void pxa_timer_resume(void)
- {
- OSMR0 = osmr[0];
- OSMR1 = osmr[1];
- OSMR2 = osmr[2];
- OSMR3 = osmr[3];
- OIER = oier;
- /*
- * OSMR0 is the system timer: make sure OSCR is sufficiently behind
- */
- OSCR = OSMR0 - LATCH;
- }
- #else
- #define pxa_timer_suspend NULL
- #define pxa_timer_resume NULL
- #endif
- struct sys_timer pxa_timer = {
- .init = pxa_timer_init,
- .suspend = pxa_timer_suspend,
- .resume = pxa_timer_resume,
- #ifdef CONFIG_NO_IDLE_HZ
- .dyn_tick = &pxa_dyn_tick,
- #endif
- };
|