linux-vybrid_public/drivers/mmc/host/sdhci.h

/*
 *  linux/drivers/mmc/host/sdhci.h - Secure Digital Host Controller Interface driver
 *
 *  Copyright (C) 2005-2008 Pierre Ossman, All Rights Reserved.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation; either version 2 of the License, or (at
 * your option) any later version.
 */

/*
 * Controller registers
 */

#define SDHCI_DMA_ADDRESS	0x00

#define SDHCI_BLOCK_SIZE	0x04
#define  SDHCI_MAKE_BLKSZ(dma, blksz) (((dma & 0x7) << 12) | (blksz & 0xFFF))

#define SDHCI_BLOCK_COUNT	0x06

#define SDHCI_ARGUMENT		0x08

#define SDHCI_TRANSFER_MODE	0x0C
#define  SDHCI_TRNS_DMA		0x01
#define  SDHCI_TRNS_BLK_CNT_EN	0x02
#define  SDHCI_TRNS_ACMD12	0x04
#define  SDHCI_TRNS_READ	0x10
#define  SDHCI_TRNS_MULTI	0x20

#define SDHCI_COMMAND		0x0E
#define  SDHCI_CMD_RESP_MASK	0x03
#define  SDHCI_CMD_CRC		0x08
#define  SDHCI_CMD_INDEX	0x10
#define  SDHCI_CMD_DATA		0x20

#define  SDHCI_CMD_RESP_NONE	0x00
#define  SDHCI_CMD_RESP_LONG	0x01
#define  SDHCI_CMD_RESP_SHORT	0x02
#define  SDHCI_CMD_RESP_SHORT_BUSY 0x03

#define SDHCI_MAKE_CMD(c, f) (((c & 0xff) << 8) | (f & 0xff))

#define SDHCI_RESPONSE		0x10

#define SDHCI_BUFFER		0x20

#define SDHCI_PRESENT_STATE	0x24
#define  SDHCI_CMD_INHIBIT	0x00000001
#define  SDHCI_DATA_INHIBIT	0x00000002
#define  SDHCI_DOING_WRITE	0x00000100
#define  SDHCI_DOING_READ	0x00000200
#define  SDHCI_SPACE_AVAILABLE	0x00000400
#define  SDHCI_DATA_AVAILABLE	0x00000800
#define  SDHCI_CARD_PRESENT	0x00010000
#define  SDHCI_WRITE_PROTECT	0x00080000

#define SDHCI_HOST_CONTROL 	0x28
#define  SDHCI_CTRL_LED		0x01
#define  SDHCI_CTRL_4BITBUS	0x02
#define  SDHCI_CTRL_HISPD	0x04

#define SDHCI_POWER_CONTROL	0x29
#define  SDHCI_POWER_ON		0x01
#define  SDHCI_POWER_180	0x0A
#define  SDHCI_POWER_300	0x0C
#define  SDHCI_POWER_330	0x0E

#define SDHCI_BLOCK_GAP_CONTROL	0x2A

#define SDHCI_WAKE_UP_CONTROL	0x2B

#define SDHCI_CLOCK_CONTROL	0x2C
#define  SDHCI_DIVIDER_SHIFT	8
#define  SDHCI_CLOCK_CARD_EN	0x0004
#define  SDHCI_CLOCK_INT_STABLE	0x0002
#define  SDHCI_CLOCK_INT_EN	0x0001

#define SDHCI_TIMEOUT_CONTROL	0x2E

#define SDHCI_SOFTWARE_RESET	0x2F
#define  SDHCI_RESET_ALL	0x01
#define  SDHCI_RESET_CMD	0x02
#define  SDHCI_RESET_DATA	0x04

#define SDHCI_INT_STATUS	0x30
#define SDHCI_INT_ENABLE	0x34
#define SDHCI_SIGNAL_ENABLE	0x38
#define  SDHCI_INT_RESPONSE	0x00000001
#define  SDHCI_INT_DATA_END	0x00000002
#define  SDHCI_INT_DMA_END	0x00000008
#define  SDHCI_INT_SPACE_AVAIL	0x00000010
#define  SDHCI_INT_DATA_AVAIL	0x00000020
#define  SDHCI_INT_CARD_INSERT	0x00000040
#define  SDHCI_INT_CARD_REMOVE	0x00000080
#define  SDHCI_INT_CARD_INT	0x00000100
#define  SDHCI_INT_ERROR	0x00008000
#define  SDHCI_INT_TIMEOUT	0x00010000
#define  SDHCI_INT_CRC		0x00020000
#define  SDHCI_INT_END_BIT	0x00040000
#define  SDHCI_INT_INDEX	0x00080000
#define  SDHCI_INT_DATA_TIMEOUT	0x00100000
#define  SDHCI_INT_DATA_CRC	0x00200000
#define  SDHCI_INT_DATA_END_BIT	0x00400000
#define  SDHCI_INT_BUS_POWER	0x00800000
#define  SDHCI_INT_ACMD12ERR	0x01000000

#define  SDHCI_INT_NORMAL_MASK	0x00007FFF
#define  SDHCI_INT_ERROR_MASK	0xFFFF8000

#define  SDHCI_INT_CMD_MASK	(SDHCI_INT_RESPONSE | SDHCI_INT_TIMEOUT | \
		SDHCI_INT_CRC | SDHCI_INT_END_BIT | SDHCI_INT_INDEX)
#define  SDHCI_INT_DATA_MASK	(SDHCI_INT_DATA_END | SDHCI_INT_DMA_END | \
		SDHCI_INT_DATA_AVAIL | SDHCI_INT_SPACE_AVAIL | \
		SDHCI_INT_DATA_TIMEOUT | SDHCI_INT_DATA_CRC | \
		SDHCI_INT_DATA_END_BIT)

#define SDHCI_ACMD12_ERR	0x3C

/* 3E-3F reserved */

#define SDHCI_CAPABILITIES	0x40
#define  SDHCI_TIMEOUT_CLK_MASK	0x0000003F
#define  SDHCI_TIMEOUT_CLK_SHIFT 0
#define  SDHCI_TIMEOUT_CLK_UNIT	0x00000080
#define  SDHCI_CLOCK_BASE_MASK	0x00003F00
#define  SDHCI_CLOCK_BASE_SHIFT	8
#define  SDHCI_MAX_BLOCK_MASK	0x00030000
#define  SDHCI_MAX_BLOCK_SHIFT  16
#define  SDHCI_CAN_DO_HISPD	0x00200000
#define  SDHCI_CAN_DO_DMA	0x00400000
#define  SDHCI_CAN_VDD_330	0x01000000
#define  SDHCI_CAN_VDD_300	0x02000000
#define  SDHCI_CAN_VDD_180	0x04000000

/* 44-47 reserved for more caps */

#define SDHCI_MAX_CURRENT	0x48

/* 4C-4F reserved for more max current */

/* 50-FB reserved */

#define SDHCI_SLOT_INT_STATUS	0xFC

#define SDHCI_HOST_VERSION	0xFE
#define  SDHCI_VENDOR_VER_MASK	0xFF00
#define  SDHCI_VENDOR_VER_SHIFT	8
#define  SDHCI_SPEC_VER_MASK	0x00FF
#define  SDHCI_SPEC_VER_SHIFT	0

struct sdhci_ops;

struct sdhci_host {
	/* Data set by hardware interface driver */
	const char		*hw_name;	/* Hardware bus name */

	unsigned int		quirks;		/* Deviations from spec. */

/* Controller doesn't honor resets unless we touch the clock register */
#define SDHCI_QUIRK_CLOCK_BEFORE_RESET			(1<<0)
/* Controller has bad caps bits, but really supports DMA */
#define SDHCI_QUIRK_FORCE_DMA				(1<<1)
/* Controller doesn't like to be reset when there is no card inserted. */
#define SDHCI_QUIRK_NO_CARD_NO_RESET			(1<<2)
/* Controller doesn't like clearing the power reg before a change */
#define SDHCI_QUIRK_SINGLE_POWER_WRITE			(1<<3)
/* Controller has flaky internal state so reset it on each ios change */
#define SDHCI_QUIRK_RESET_CMD_DATA_ON_IOS		(1<<4)
/* Controller has an unusable DMA engine */
#define SDHCI_QUIRK_BROKEN_DMA				(1<<5)
/* Controller can only DMA from 32-bit aligned addresses */
#define SDHCI_QUIRK_32BIT_DMA_ADDR			(1<<6)
/* Controller can only DMA chunk sizes that are a multiple of 32 bits */
#define SDHCI_QUIRK_32BIT_DMA_SIZE			(1<<7)
/* Controller needs to be reset after each request to stay stable */
#define SDHCI_QUIRK_RESET_AFTER_REQUEST			(1<<8)
/* Controller needs voltage and power writes to happen separately */
#define SDHCI_QUIRK_NO_SIMULT_VDD_AND_POWER		(1<<9)
/* Controller provides an incorrect timeout value for transfers */
#define SDHCI_QUIRK_BROKEN_TIMEOUT_VAL			(1<<10)

	int			irq;		/* Device IRQ */
	void __iomem *		ioaddr;		/* Mapped address */

	const struct sdhci_ops	*ops;		/* Low level hw interface */

	/* Internal data */
	struct mmc_host		*mmc;		/* MMC structure */

#ifdef CONFIG_LEDS_CLASS
	struct led_classdev	led;		/* LED control */
#endif

	spinlock_t		lock;		/* Mutex */

	int			flags;		/* Host attributes */
#define SDHCI_USE_DMA		(1<<0)		/* Host is DMA capable */
#define SDHCI_REQ_USE_DMA	(1<<1)		/* Use DMA for this req. */
#define SDHCI_DEVICE_DEAD	(1<<2)		/* Device unresponsive */

	unsigned int		max_clk;	/* Max possible freq (MHz) */
	unsigned int		timeout_clk;	/* Timeout freq (KHz) */

	unsigned int		clock;		/* Current clock (MHz) */
	unsigned short		power;		/* Current voltage */

	struct mmc_request	*mrq;		/* Current request */
	struct mmc_command	*cmd;		/* Current command */
	struct mmc_data		*data;		/* Current data request */
	unsigned int		data_early:1;	/* Data finished before cmd */

	struct scatterlist	*cur_sg;	/* We're working on this */
	int			num_sg;		/* Entries left */
	int			offset;		/* Offset into current sg */
	int			remain;		/* Bytes left in current */

	struct tasklet_struct	card_tasklet;	/* Tasklet structures */
	struct tasklet_struct	finish_tasklet;

	struct timer_list	timer;		/* Timer for timeouts */

	unsigned long		private[0] ____cacheline_aligned;
};


struct sdhci_ops {
	int		(*enable_dma)(struct sdhci_host *host);
};


extern struct sdhci_host *sdhci_alloc_host(struct device *dev,
	size_t priv_size);
extern void sdhci_free_host(struct sdhci_host *host);

static inline void *sdhci_priv(struct sdhci_host *host)
{
	return (void *)host->private;
}

extern int sdhci_add_host(struct sdhci_host *host);
extern void sdhci_remove_host(struct sdhci_host *host, int dead);

#ifdef CONFIG_PM
extern int sdhci_suspend_host(struct sdhci_host *host, pm_message_t state);
extern int sdhci_resume_host(struct sdhci_host *host);
#endif