b44: Unconditionally enable interrupt routing on reset

Unconditionally setup the IRQ routing on chip reset.
It's safe to call ssb_pcicore_dev_irqvecs_enable() unconditionally, because
it has internal checks for redundant calls.

This fixes problems where hardware will not come up properly
due to quirks in the enable-bit hardware.

Reported-by: Pantelis Koukousoulas <pktoss@gmail.com>
Signed-off-by: Michael Buesch <mb@bu3sch.de>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/b44.c

@@ -1264,8 +1264,14 @@ static void b44_clear_stats(struct b44 *bp)
 static void b44_chip_reset(struct b44 *bp, int reset_kind)
 {
 	struct ssb_device *sdev = bp->sdev;
+	bool was_enabled;
 
-	if (ssb_device_is_enabled(bp->sdev)) {
+	was_enabled = ssb_device_is_enabled(bp->sdev);
+
+	ssb_device_enable(bp->sdev, 0);
+	ssb_pcicore_dev_irqvecs_enable(&sdev->bus->pcicore, sdev);
+
+	if (was_enabled) {
 		bw32(bp, B44_RCV_LAZY, 0);
 		bw32(bp, B44_ENET_CTRL, ENET_CTRL_DISABLE);
 		b44_wait_bit(bp, B44_ENET_CTRL, ENET_CTRL_DISABLE, 200, 1);
@@ -1277,10 +1283,8 @@ static void b44_chip_reset(struct b44 *bp, int reset_kind)
 		}
 		bw32(bp, B44_DMARX_CTRL, 0);
 		bp->rx_prod = bp->rx_cons = 0;
-	} else
-		ssb_pcicore_dev_irqvecs_enable(&sdev->bus->pcicore, sdev);
+	}
 
-	ssb_device_enable(bp->sdev, 0);
 	b44_clear_stats(bp);
 
 	/*