iwlwifi: mvm: configure power management in D3

Configure power management in the D3 firmware by sending
the power table command to it when suspending; this uses
some values that are more suitable to a low power state.

Signed-off-by: Alexander Bondar <alexander.bondar@intel.com>
Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

drivers/net/wireless/iwlwifi/mvm/d3.c

@@ -1007,6 +1007,10 @@ int iwl_mvm_suspend(struct ieee80211_hw *hw, struct cfg80211_wowlan *wowlan)
 	if (ret)
 		goto out;
 
+	ret = iwl_mvm_power_update_mode(mvm, vif);
+	if (ret)
+		goto out;
+
 	/* must be last -- this switches firmware state */
 	ret = iwl_mvm_send_cmd_pdu(mvm, D3_CONFIG_CMD, CMD_SYNC,
 				   sizeof(d3_cfg_cmd), &d3_cfg_cmd);

drivers/net/wireless/iwlwifi/mvm/power.c

@@ -138,7 +138,8 @@ void iwl_mvm_power_build_cmd(struct iwl_mvm *mvm, struct ieee80211_vif *vif,
 
 	/* Check skip over DTIM conditions */
 	if (!radar_detect && (dtimper <= 10) &&
-	    (iwlmvm_mod_params.power_scheme == IWL_POWER_SCHEME_LP)) {
+	    (iwlmvm_mod_params.power_scheme == IWL_POWER_SCHEME_LP ||
+	     mvm->cur_ucode == IWL_UCODE_WOWLAN)) {
 		cmd->flags |= cpu_to_le16(POWER_FLAGS_SKIP_OVER_DTIM_MSK);
 		cmd->num_skip_dtim = cpu_to_le32(2);
 	}
@@ -150,8 +151,13 @@ void iwl_mvm_power_build_cmd(struct iwl_mvm *mvm, struct ieee80211_vif *vif,
 	keep_alive = DIV_ROUND_UP(keep_alive, MSEC_PER_SEC);
 	cmd->keep_alive_seconds = keep_alive;
 
-	cmd->rx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
-	cmd->tx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
+	if (mvm->cur_ucode != IWL_UCODE_WOWLAN) {
+		cmd->rx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
+		cmd->tx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
+	} else {
+		cmd->rx_data_timeout = cpu_to_le32(10 * USEC_PER_MSEC);
+		cmd->tx_data_timeout = cpu_to_le32(10 * USEC_PER_MSEC);
+	}
 }
 
 int iwl_mvm_power_update_mode(struct iwl_mvm *mvm, struct ieee80211_vif *vif)