ARM: OMAP: No need to include board-h2.h from hardware.h

Also move board-h2.h to mach-omap1.

Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap1/board-h2-mmc.c

@@ -19,6 +19,8 @@
 #include <mach/mmc.h>
 #include <mach/gpio.h>
 
+#include "board-h2.h"
+
 #if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE)
 
 static int mmc_set_power(struct device *dev, int slot, int power_on,

arch/arm/mach-omap1/board-h2.c

@@ -46,6 +46,11 @@
 #include <mach/keypad.h>
 #include <mach/common.h>
 
+#include "board-h2.h"
+
+/* At OMAP1610 Innovator the Ethernet is directly connected to CS1 */
+#define OMAP1610_ETHR_START		0x04000300
+
 static int h2_keymap[] = {
 	KEY(0, 0, KEY_LEFT),
 	KEY(0, 1, KEY_RIGHT),

arch/arm/plat-omap/include/mach/board-h2.h → arch/arm/mach-omap1/board-h2.h

@@ -1,5 +1,5 @@
 /*
- * arch/arm/plat-omap/include/mach/board-h2.h
+ * arch/arm/mach-omap1/board-h2.h
  *
  * Hardware definitions for TI OMAP1610 H2 board.
  *
@@ -29,9 +29,6 @@
 #ifndef __ASM_ARCH_OMAP_H2_H
 #define __ASM_ARCH_OMAP_H2_H
 
-/* At OMAP1610 Innovator the Ethernet is directly connected to CS1 */
-#define OMAP1610_ETHR_START		0x04000300
-
 #define H2_TPS_GPIO_BASE		(OMAP_MAX_GPIO_LINES + 16 /* MPUIO */)
 #	define H2_TPS_GPIO_MMC_PWR_EN	(H2_TPS_GPIO_BASE + 3)
 

arch/arm/plat-omap/include/mach/hardware.h

@@ -298,10 +298,6 @@
 #include "board-innovator.h"
 #endif
 
-#ifdef CONFIG_MACH_OMAP_H2
-#include "board-h2.h"
-#endif
-
 #ifdef CONFIG_MACH_OMAP_H3
 #include "board-h3.h"
 #endif