mach-ux500: fix i2c0 device setup regression

Adding two sets of I2C devices to the same bus doesn't quite work,
atleast not anymore. Stash one array and determine how much of it
shall be added instead.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

arch/arm/mach-ux500/board-mop500.c

@@ -178,16 +178,15 @@ static struct i2c_board_info __initdata mop500_i2c0_devices[] = {
 		.irq		= NOMADIK_GPIO_TO_IRQ(217),
 		.platform_data  = &mop500_tc35892_data,
 	},
-};
-
-/* I2C0 devices only available prior to HREFv60 */
-static struct i2c_board_info __initdata mop500_i2c0_old_devices[] = {
+	/* I2C0 devices only available prior to HREFv60 */
 	{
 		I2C_BOARD_INFO("tps61052", 0x33),
 		.platform_data  = &mop500_tps61052_data,
 	},
 };
 
+#define NUM_PRE_V60_I2C0_DEVICES 1
+
 static struct i2c_board_info __initdata mop500_i2c2_devices[] = {
 	{
 		/* lp5521 LED driver, 1st device */
@@ -425,6 +424,8 @@ static void __init mop500_uart_init(void)
 
 static void __init mop500_init_machine(void)
 {
+	int i2c0_devs;
+
 	/*
 	 * The HREFv60 board removed a GPIO expander and routed
 	 * all these GPIO pins to the internal GPIO controller
@@ -448,11 +449,11 @@ static void __init mop500_init_machine(void)
 
 	platform_device_register(&ab8500_device);
 
-	i2c_register_board_info(0, mop500_i2c0_devices,
-				ARRAY_SIZE(mop500_i2c0_devices));
-	if (!machine_is_hrefv60())
-		i2c_register_board_info(0, mop500_i2c0_old_devices,
-					ARRAY_SIZE(mop500_i2c0_old_devices));
+	i2c0_devs = ARRAY_SIZE(mop500_i2c0_devices);
+	if (machine_is_hrefv60())
+		i2c0_devs -= NUM_PRE_V60_I2C0_DEVICES;
+
+	i2c_register_board_info(0, mop500_i2c0_devices, i2c0_devs);
 	i2c_register_board_info(2, mop500_i2c2_devices,
 				ARRAY_SIZE(mop500_i2c2_devices));
 }