e1000e: indicate link down at load

As reported by Andrew Lutomirski <amluto@gmail.com>

All the intel wired ethernet drivers were calling netif_carrier_off
and netif_stop_queue (or variants) before calling register_netdevice

This is incorrect behavior as was pointed out by davem, and causes
ifconfig and friends to report a strange state before first link
after the driver was loaded, since without a netif_carrier_off, the stack
assumes carrier_on, but before register_netdev, netlink messages are not
sent out telling link state.

This apparently confused *some* versions of networkmanager.

Andy tested this for e1000e and confirmed it was working for him.

see thread: http://marc.info/?l=linux-netdev&m=123946479705636&w=2

Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Tested-by: Andy Lutomirski <amluto@gmail.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/e1000e/netdev.c

@@ -3072,6 +3072,8 @@ static int e1000_open(struct net_device *netdev)
 	if (test_bit(__E1000_TESTING, &adapter->state))
 		return -EBUSY;
 
+	netif_carrier_off(netdev);
+
 	/* allocate transmit descriptors */
 	err = e1000e_setup_tx_resources(adapter);
 	if (err)
@@ -5037,15 +5039,14 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
 	if (!(adapter->flags & FLAG_HAS_AMT))
 		e1000_get_hw_control(adapter);
 
-	/* tell the stack to leave us alone until e1000_open() is called */
-	netif_carrier_off(netdev);
-	netif_tx_stop_all_queues(netdev);
-
 	strcpy(netdev->name, "eth%d");
 	err = register_netdev(netdev);
 	if (err)
 		goto err_register;
 
+	/* carrier off reporting is important to ethtool even BEFORE open */
+	netif_carrier_off(netdev);
+
 	e1000_print_device_info(adapter);
 
 	return 0;