atl1c: remove REG_PHY_STATUS

this register is used for l1e(dev=1026)
l1c/l1d/l2cb don't use it.

Signed-off-by: xiong <xiong@qca.qualcomm.com>
Tested-by: Liu David <dwliu@qca.qualcomm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/atheros/atl1c/atl1c_hw.h

@@ -293,13 +293,6 @@ int atl1c_phy_power_saving(struct atl1c_hw *hw);
 #define MDIO_AP_EN              	0x10000000
 #define MDIO_WAIT_TIMES         	10
 
-/* MII PHY Status Register */
-#define REG_PHY_STATUS           	0x1418
-#define PHY_GENERAL_STATUS_MASK		0xFFFF
-#define PHY_STATUS_RECV_ENABLE		0x0001
-#define PHY_OE_PWSP_STATUS_MASK		0x07FF
-#define PHY_OE_PWSP_STATUS_SHIFT	16
-#define PHY_STATUS_LPW_STATE		0x80000000
 /* BIST Control and Status Register0 (for the Packet Memory) */
 #define REG_BIST0_CTRL              	0x141c
 #define BIST0_NOW                   	0x1

drivers/net/ethernet/atheros/atl1c/atl1c_main.c

@@ -699,11 +699,9 @@ static void atl1c_set_mac_type(struct atl1c_hw *hw)
 
 static int atl1c_setup_mac_funcs(struct atl1c_hw *hw)
 {
-	u32 phy_status_data;
 	u32 link_ctrl_data;
 
 	atl1c_set_mac_type(hw);
-	AT_READ_REG(hw, REG_PHY_STATUS, &phy_status_data);
 	AT_READ_REG(hw, REG_LINK_CTRL, &link_ctrl_data);
 
 	hw->ctrl_flags = ATL1C_INTR_MODRT_ENABLE  |