ARM/USB: at91/ohci-at91: rename vbus_pin_inverted to vbus_pin_active_low

Allows to configure independently the vbus_pin associated with each port.
Matches usual naming scheme.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: Greg Kroah-Hartman <gregkh@suse.de>
Cc: linux-usb@vger.kernel.org

arch/arm/mach-at91/include/mach/board.h

@@ -88,7 +88,7 @@ extern void __init at91_add_device_eth(struct macb_platform_data *data);
 struct at91_usbh_data {
 	u8		ports;		/* number of ports on root hub */
 	int		vbus_pin[2];	/* port power-control pin */
-	u8              vbus_pin_inverted;
+	u8              vbus_pin_active_low[2];
 	u8              overcurrent_supported;
 	int             overcurrent_pin[2];
 	u8              overcurrent_status[2];

drivers/usb/host/ohci-at91.c

@@ -244,7 +244,8 @@ static void ohci_at91_usb_set_power(struct at91_usbh_data *pdata, int port, int
 	if (!gpio_is_valid(pdata->vbus_pin[port]))
 		return;
 
-	gpio_set_value(pdata->vbus_pin[port], !pdata->vbus_pin_inverted ^ enable);
+	gpio_set_value(pdata->vbus_pin[port],
+		       !pdata->vbus_pin_active_low[port] ^ enable);
 }
 
 static int ohci_at91_usb_get_power(struct at91_usbh_data *pdata, int port)
@@ -255,7 +256,8 @@ static int ohci_at91_usb_get_power(struct at91_usbh_data *pdata, int port)
 	if (!gpio_is_valid(pdata->vbus_pin[port]))
 		return -EINVAL;
 
-	return gpio_get_value(pdata->vbus_pin[port]) ^ !pdata->vbus_pin_inverted;
+	return gpio_get_value(pdata->vbus_pin[port]) ^
+		!pdata->vbus_pin_active_low[port];
 }
 
 /*