can: c_can: Add support for Bosch D_CAN controller

This patch adds the support for D_CAN controller driver to the existing
C_CAN driver.

Bosch D_CAN controller is a full-CAN implementation which is compliant
to CAN protocol version 2.0 part A and B. Bosch D_CAN user manual can be
obtained from: http://www.semiconductors.bosch.de/media/en/pdf/
ipmodules_1/can/d_can_users_manual_111.pdf

A new array is added for accessing the d_can registers, according to d_can
controller register space.

Current D_CAN implementation has following limitations, this is done
to avoid large changes to the C_CAN driver.
1. Message objects are limited to 32, 16 for RX and 16 for TX. C_CAN IP
   supports upto 32 message objects but in case of D_CAN we can configure
   upto 128 message objects.
2. Using two 16bit reads/writes for accessing the 32bit D_CAN registers.
3. These patches have been tested on little endian machine, there might
   be some hidden endian-related issues due to the nature of the accesses
   (32-bit registers accessed as 2 16-bit registers). However, I do not
   have a big-endian D_CAN implementation to confirm.

Signed-off-by: AnilKumar Ch <anilkumar@ti.com>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>

drivers/net/can/c_can/Kconfig

@@ -1,15 +1,16 @@
 menuconfig CAN_C_CAN
-	tristate "Bosch C_CAN devices"
+	tristate "Bosch C_CAN/D_CAN devices"
 	depends on CAN_DEV && HAS_IOMEM
 
 if CAN_C_CAN
 
 config CAN_C_CAN_PLATFORM
-	tristate "Generic Platform Bus based C_CAN driver"
+	tristate "Generic Platform Bus based C_CAN/D_CAN driver"
 	---help---
-	  This driver adds support for the C_CAN chips connected to
-	  the "platform bus" (Linux abstraction for directly to the
+	  This driver adds support for the C_CAN/D_CAN chips connected
+	  to the "platform bus" (Linux abstraction for directly to the
 	  processor attached devices) which can be found on various
-	  boards from ST Microelectronics (http://www.st.com)
-	  like the SPEAr1310 and SPEAr320 evaluation boards.
+	  boards from ST Microelectronics (http://www.st.com) like the
+	  SPEAr1310 and SPEAr320 evaluation boards & TI (www.ti.com)
+	  boards like am335x, dm814x, dm813x and dm811x.
 endif

drivers/net/can/c_can/c_can.h

@@ -102,6 +102,51 @@ static const u16 reg_map_c_can[] = {
 	[C_CAN_MSGVAL2_REG]	= 0xB2,
 };
 
+static const u16 reg_map_d_can[] = {
+	[C_CAN_CTRL_REG]	= 0x00,
+	[C_CAN_STS_REG]		= 0x04,
+	[C_CAN_ERR_CNT_REG]	= 0x08,
+	[C_CAN_BTR_REG]		= 0x0C,
+	[C_CAN_BRPEXT_REG]	= 0x0E,
+	[C_CAN_INT_REG]		= 0x10,
+	[C_CAN_TEST_REG]	= 0x14,
+	[C_CAN_TXRQST1_REG]	= 0x88,
+	[C_CAN_TXRQST2_REG]	= 0x8A,
+	[C_CAN_NEWDAT1_REG]	= 0x9C,
+	[C_CAN_NEWDAT2_REG]	= 0x9E,
+	[C_CAN_INTPND1_REG]	= 0xB0,
+	[C_CAN_INTPND2_REG]	= 0xB2,
+	[C_CAN_MSGVAL1_REG]	= 0xC4,
+	[C_CAN_MSGVAL2_REG]	= 0xC6,
+	[C_CAN_IF1_COMREQ_REG]	= 0x100,
+	[C_CAN_IF1_COMMSK_REG]	= 0x102,
+	[C_CAN_IF1_MASK1_REG]	= 0x104,
+	[C_CAN_IF1_MASK2_REG]	= 0x106,
+	[C_CAN_IF1_ARB1_REG]	= 0x108,
+	[C_CAN_IF1_ARB2_REG]	= 0x10A,
+	[C_CAN_IF1_MSGCTRL_REG]	= 0x10C,
+	[C_CAN_IF1_DATA1_REG]	= 0x110,
+	[C_CAN_IF1_DATA2_REG]	= 0x112,
+	[C_CAN_IF1_DATA3_REG]	= 0x114,
+	[C_CAN_IF1_DATA4_REG]	= 0x116,
+	[C_CAN_IF2_COMREQ_REG]	= 0x120,
+	[C_CAN_IF2_COMMSK_REG]	= 0x122,
+	[C_CAN_IF2_MASK1_REG]	= 0x124,
+	[C_CAN_IF2_MASK2_REG]	= 0x126,
+	[C_CAN_IF2_ARB1_REG]	= 0x128,
+	[C_CAN_IF2_ARB2_REG]	= 0x12A,
+	[C_CAN_IF2_MSGCTRL_REG]	= 0x12C,
+	[C_CAN_IF2_DATA1_REG]	= 0x130,
+	[C_CAN_IF2_DATA2_REG]	= 0x132,
+	[C_CAN_IF2_DATA3_REG]	= 0x134,
+	[C_CAN_IF2_DATA4_REG]	= 0x136,
+};
+
+enum c_can_dev_id {
+	C_CAN_DEVTYPE,
+	D_CAN_DEVTYPE,
+};
+
 /* c_can private data structure */
 struct c_can_priv {
 	struct can_priv can;	/* must be the first member */

drivers/net/can/c_can/c_can_platform.c

@@ -71,6 +71,7 @@ static int __devinit c_can_plat_probe(struct platform_device *pdev)
 	void __iomem *addr;
 	struct net_device *dev;
 	struct c_can_priv *priv;
+	const struct platform_device_id *id;
 	struct resource *mem;
 	int irq;
 #ifdef CONFIG_HAVE_CLK
@@ -115,7 +116,32 @@ static int __devinit c_can_plat_probe(struct platform_device *pdev)
 	}
 
 	priv = netdev_priv(dev);
-	priv->regs = reg_map_c_can;
+	id = platform_get_device_id(pdev);
+	switch (id->driver_data) {
+	case C_CAN_DEVTYPE:
+		priv->regs = reg_map_c_can;
+		switch (mem->flags & IORESOURCE_MEM_TYPE_MASK) {
+		case IORESOURCE_MEM_32BIT:
+			priv->read_reg = c_can_plat_read_reg_aligned_to_32bit;
+			priv->write_reg = c_can_plat_write_reg_aligned_to_32bit;
+			break;
+		case IORESOURCE_MEM_16BIT:
+		default:
+			priv->read_reg = c_can_plat_read_reg_aligned_to_16bit;
+			priv->write_reg = c_can_plat_write_reg_aligned_to_16bit;
+			break;
+		}
+		break;
+	case D_CAN_DEVTYPE:
+		priv->regs = reg_map_d_can;
+		priv->can.ctrlmode_supported |= CAN_CTRLMODE_3_SAMPLES;
+		priv->read_reg = c_can_plat_read_reg_aligned_to_16bit;
+		priv->write_reg = c_can_plat_write_reg_aligned_to_16bit;
+		break;
+	default:
+		ret = -EINVAL;
+		goto exit_free_device;
+	}
 
 	dev->irq = irq;
 	priv->base = addr;
@@ -124,18 +150,6 @@ static int __devinit c_can_plat_probe(struct platform_device *pdev)
 	priv->priv = clk;
 #endif
 
-	switch (mem->flags & IORESOURCE_MEM_TYPE_MASK) {
-	case IORESOURCE_MEM_32BIT:
-		priv->read_reg = c_can_plat_read_reg_aligned_to_32bit;
-		priv->write_reg = c_can_plat_write_reg_aligned_to_32bit;
-		break;
-	case IORESOURCE_MEM_16BIT:
-	default:
-		priv->read_reg = c_can_plat_read_reg_aligned_to_16bit;
-		priv->write_reg = c_can_plat_write_reg_aligned_to_16bit;
-		break;
-	}
-
 	platform_set_drvdata(pdev, dev);
 	SET_NETDEV_DEV(dev, &pdev->dev);
 
@@ -189,6 +203,20 @@ static int __devexit c_can_plat_remove(struct platform_device *pdev)
 	return 0;
 }
 
+static const struct platform_device_id c_can_id_table[] = {
+	{
+		.name = KBUILD_MODNAME,
+		.driver_data = C_CAN_DEVTYPE,
+	}, {
+		.name = "c_can",
+		.driver_data = C_CAN_DEVTYPE,
+	}, {
+		.name = "d_can",
+		.driver_data = D_CAN_DEVTYPE,
+	}, {
+	}
+};
+
 static struct platform_driver c_can_plat_driver = {
 	.driver = {
 		.name = KBUILD_MODNAME,
@@ -196,6 +224,7 @@ static struct platform_driver c_can_plat_driver = {
 	},
 	.probe = c_can_plat_probe,
 	.remove = __devexit_p(c_can_plat_remove),
+	.id_table = c_can_id_table,
 };
 
 module_platform_driver(c_can_plat_driver);