[SCSI] qla2xxx: Correct synchronization of software/firmware fcport states.

Greg Wettstein (greg@enjellic.com) noted:

	http://article.gmane.org/gmane.linux.scsi/43409

on a reboot of a previously recognized SCST target, the initiator
driver would be unable to re-recognize the device as a target.
It turns out that prior to the SCST software reloading and
returning it's "target-capable" abilities in the PRLI payload,
the HBA would be re-initialized as an initiator-only type port.
Since initiators typically classify themselves as an FCP-2
capable device, both software and firmware do not perform an
explicit logout during port-loss.  Unfortunately, as can be seen
by the failure case, when the port (now target-capable) returns,
firmware performs an ADISC without a follow-on PRLI, leaving
stale 'initiator-only' data in the firmware's port database.

Correct the discrepancy by performing the explicit logout during
the transport's request to terminate-rport-io, thus synchronizing
port states and ensuring a follow-on PRLI is performed.

Reported-by: Greg Wettstein <greg@enjellic.com>
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Cc: Stable Tree <stable@kernel.org>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/qla2xxx/qla_attr.c

@@ -993,6 +993,17 @@ qla2x00_terminate_rport_io(struct fc_rport *rport)
 {
 	fc_port_t *fcport = *(fc_port_t **)rport->dd_data;
 
+	/*
+	 * At this point all fcport's software-states are cleared.  Perform any
+	 * final cleanup of firmware resources (PCBs and XCBs).
+	 */
+	if (fcport->loop_id != FC_NO_LOOP_ID) {
+		fcport->ha->isp_ops->fabric_logout(fcport->ha, fcport->loop_id,
+		    fcport->d_id.b.domain, fcport->d_id.b.area,
+		    fcport->d_id.b.al_pa);
+		fcport->loop_id = FC_NO_LOOP_ID;
+	}
+
 	qla2x00_abort_fcport_cmds(fcport);
 	scsi_target_unblock(&rport->dev);
 }