b43: LP-PHY: Two small spec updates

The specs are beginning to support rev3 LP-PHYs - implement one of
the changes needed for rev3 support.
Also, in the new MIPS driver, the "Japan TX filter" was renamed to
"analog TX filter init" - however, calling it "init" is confusing,
so name it "set analog filter", with a comment for easier future
identification.

Signed-off-by: Gábor Stefanik <netrolller.3d@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/b43/phy_lp.c

@@ -609,9 +609,14 @@ static void lpphy_2063_init(struct b43_wldev *dev)
 	b43_radio_write(dev, B2063_PA_SP7, 0);
 	b43_radio_write(dev, B2063_TX_RF_SP6, 0x20);
 	b43_radio_write(dev, B2063_TX_RF_SP9, 0x40);
-	b43_radio_write(dev, B2063_PA_SP3, 0xa0);
-	b43_radio_write(dev, B2063_PA_SP4, 0xa0);
-	b43_radio_write(dev, B2063_PA_SP2, 0x18);
+	if (dev->phy.rev == 2) {
+		b43_radio_write(dev, B2063_PA_SP3, 0xa0);
+		b43_radio_write(dev, B2063_PA_SP4, 0xa0);
+		b43_radio_write(dev, B2063_PA_SP2, 0x18);
+	} else {
+		b43_radio_write(dev, B2063_PA_SP3, 0x20);
+		b43_radio_write(dev, B2063_PA_SP2, 0x20);
+	}
 }
 
 struct lpphy_stx_table_entry {
@@ -1972,7 +1977,9 @@ static int lpphy_b2062_tune(struct b43_wldev *dev,
 	return err;
 }
 
-static void lpphy_japan_filter(struct b43_wldev *dev, int channel)
+
+/* This was previously called lpphy_japan_filter */
+static void lpphy_set_analog_filter(struct b43_wldev *dev, int channel)
 {
 	struct b43_phy_lp *lpphy = dev->phy.lp;
 	u16 tmp = (channel == 14); //SPEC FIXME check japanwidefilter!
@@ -2141,7 +2148,7 @@ static int b43_lpphy_op_switch_channel(struct b43_wldev *dev,
 		err = lpphy_b2062_tune(dev, new_channel);
 		if (err)
 			return err;
-		lpphy_japan_filter(dev, new_channel);
+		lpphy_set_analog_filter(dev, new_channel);
 		lpphy_adjust_gain_table(dev, channel2freq_lp(new_channel));
 	}