[media] radio-keene: set initial frequency

The device was never set to the initial frequency.

Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

drivers/media/radio/radio-keene.c

@@ -93,7 +93,7 @@ static int keene_cmd_main(struct keene_device *radio, unsigned freq, bool play)
 	/* If bit 4 is set, then tune to the frequency.
 	   If bit 3 is set, then unmute; if bit 2 is set, then mute.
 	   If bit 1 is set, then enter idle mode; if bit 0 is set,
-	   then enter transit mode.
+	   then enter transmit mode.
 	 */
 	radio->buffer[5] = (radio->muted ? 4 : 8) | (play ? 1 : 2) |
 							(freq ? 0x10 : 0);
@@ -350,7 +350,6 @@ static int usb_keene_probe(struct usb_interface *intf,
 	radio->pa = 118;
 	radio->tx = 0x32;
 	radio->stereo = true;
-	radio->curfreq = 95.16 * FREQ_MUL;
 	if (hdl->error) {
 		retval = hdl->error;
 
@@ -383,6 +382,8 @@ static int usb_keene_probe(struct usb_interface *intf,
 	video_set_drvdata(&radio->vdev, radio);
 	set_bit(V4L2_FL_USE_FH_PRIO, &radio->vdev.flags);
 
+	keene_cmd_main(radio, 95.16 * FREQ_MUL, false);
+
 	retval = video_register_device(&radio->vdev, VFL_TYPE_RADIO, -1);
 	if (retval < 0) {
 		dev_err(&intf->dev, "could not register video device\n");