NetXen: Fix ping issue after reboot on Blades with 3.4.19 firmware

NetXen: Fix initialization and subsequent ping issue on 3.4.19 firmware
This patch fixes the ping problem seen X/PBlades after the adapter's
firmware was moved to 3.4.19. After configured interface up, ping
failed.
NetXen adapter couldn't accept ARP broadcast packet. Manual addition of
MAC address in the ARP table, made ping work.
NetXen adapter should finish initilization after system boot. But looks
NetXen adapter didn't initilization correctly after system boot up.
So have to re-load the firmware again in probe routine.
Also re-initilization netxen_config_0 and netxen_config_1 registers.

Signed-off by: Wen Xiong <wenxiong@us.ibm.com>
Signed-off by: Mithlesh Thukral <mithlesh@netxen.com>

Signed-off-by: Jeff Garzik <jeff@garzik.org>

drivers/net/netxen/netxen_nic_main.c

@@ -542,6 +542,13 @@ netxen_nic_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 				NETXEN_ROMUSB_GLB_PEGTUNE_DONE));
 		/* Handshake with the card before we register the devices. */
 		netxen_phantom_init(adapter, NETXEN_NIC_PEG_TUNE);
+
+	       /* leave the hw in the same state as reboot */
+	       writel(0, NETXEN_CRB_NORMALIZE(adapter, CRB_CMDPEG_STATE));
+	       netxen_pinit_from_rom(adapter, 0);
+	       udelay(500);
+	       netxen_load_firmware(adapter);
+	       netxen_phantom_init(adapter, NETXEN_NIC_PEG_TUNE);
 	}
 
 	/*

drivers/net/netxen/netxen_nic_niu.c

@@ -454,16 +454,12 @@ int netxen_niu_gbe_init_port(struct netxen_adapter *adapter, int port)
 
 int netxen_niu_xg_init_port(struct netxen_adapter *adapter, int port)
 {
-	u32 reg;
 	u32 portnum = physical_port[adapter->portnum];
 
 	netxen_crb_writelit_adapter(adapter,
-		NETXEN_NIU_XGE_CONFIG_0+(0x10000*portnum), 0x5);
-	netxen_nic_hw_read_wx(adapter,
-		NETXEN_NIU_XGE_CONFIG_1+(0x10000*portnum), &reg, 4);
-	reg = (reg & ~0x2000UL);
+		NETXEN_NIU_XGE_CONFIG_1+(0x10000*portnum), 0x1447);
 	netxen_crb_writelit_adapter(adapter,
-		NETXEN_NIU_XGE_CONFIG_1+(0x10000*portnum), reg);
+		NETXEN_NIU_XGE_CONFIG_0+(0x10000*portnum), 0x5);
 
 	return 0;
 }