wl12xx: Add AP related configuration to conf_drv_settings

Rate class configuration has been split up for AP and STA modes.
Template related configuration likewise separated.

Signed-off-by: Arik Nemtsov <arik@wizery.com>
Reviewed-by: Luciano Coelho <coelho@ti.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>

drivers/net/wireless/wl12xx/acx.c

@@ -754,7 +754,7 @@ int wl1271_acx_statistics(struct wl1271 *wl, struct acx_statistics *stats)
 int wl1271_acx_rate_policies(struct wl1271 *wl)
 {
 	struct acx_rate_policy *acx;
-	struct conf_tx_rate_class *c = &wl->conf.tx.rc_conf;
+	struct conf_tx_rate_class *c = &wl->conf.tx.sta_rc_conf;
 	int idx = 0;
 	int ret = 0;
 

drivers/net/wireless/wl12xx/cmd.c

@@ -490,8 +490,8 @@ int wl1271_cmd_template_set(struct wl1271 *wl, u16 template_id,
 	cmd->len = cpu_to_le16(buf_len);
 	cmd->template_type = template_id;
 	cmd->enabled_rates = cpu_to_le32(rates);
-	cmd->short_retry_limit = wl->conf.tx.rc_conf.short_retry_limit;
-	cmd->long_retry_limit = wl->conf.tx.rc_conf.long_retry_limit;
+	cmd->short_retry_limit = wl->conf.tx.tmpl_short_retry_limit;
+	cmd->long_retry_limit = wl->conf.tx.tmpl_long_retry_limit;
 	cmd->index = index;
 
 	if (buf)

drivers/net/wireless/wl12xx/conf.h

@@ -496,6 +496,26 @@ struct conf_rx_settings {
 					CONF_HW_BIT_RATE_2MBPS)
 #define CONF_TX_RATE_RETRY_LIMIT       10
 
+/*
+ * Rates supported for data packets when operating as AP. Note the absense
+ * of the 22Mbps rate. There is a FW limitation on 12 rates so we must drop
+ * one. The rate dropped is not mandatory under any operating mode.
+ */
+#define CONF_TX_AP_ENABLED_RATES       (CONF_HW_BIT_RATE_1MBPS | \
+	CONF_HW_BIT_RATE_2MBPS | CONF_HW_BIT_RATE_5_5MBPS |      \
+	CONF_HW_BIT_RATE_6MBPS | CONF_HW_BIT_RATE_9MBPS |        \
+	CONF_HW_BIT_RATE_11MBPS | CONF_HW_BIT_RATE_12MBPS |      \
+	CONF_HW_BIT_RATE_18MBPS | CONF_HW_BIT_RATE_24MBPS |      \
+	CONF_HW_BIT_RATE_36MBPS | CONF_HW_BIT_RATE_48MBPS |      \
+	CONF_HW_BIT_RATE_54MBPS)
+
+/*
+ * Default rates for management traffic when operating in AP mode. This
+ * should be configured according to the basic rate set of the AP
+ */
+#define CONF_TX_AP_DEFAULT_MGMT_RATES  (CONF_HW_BIT_RATE_1MBPS | \
+	CONF_HW_BIT_RATE_2MBPS | CONF_HW_BIT_RATE_5_5MBPS)
+
 struct conf_tx_rate_class {
 
 	/*
@@ -636,9 +656,9 @@ struct conf_tx_settings {
 
 	/*
 	 * Configuration for rate classes for TX (currently only one
-	 * rate class supported.)
+	 * rate class supported). Used in non-AP mode.
 	 */
-	struct conf_tx_rate_class rc_conf;
+	struct conf_tx_rate_class sta_rc_conf;
 
 	/*
 	 * Configuration for access categories for TX rate control.
@@ -646,6 +666,22 @@ struct conf_tx_settings {
 	u8 ac_conf_count;
 	struct conf_tx_ac_category ac_conf[CONF_TX_MAX_AC_COUNT];
 
+	/*
+	 * Configuration for rate classes in AP-mode. These rate classes
+	 * are for the AC TX queues
+	 */
+	struct conf_tx_rate_class ap_rc_conf[CONF_TX_MAX_AC_COUNT];
+
+	/*
+	 * Management TX rate class for AP-mode.
+	 */
+	struct conf_tx_rate_class ap_mgmt_conf;
+
+	/*
+	 * Broadcast TX rate class for AP-mode.
+	 */
+	struct conf_tx_rate_class ap_bcst_conf;
+
 	/*
 	 * Configuration for TID parameters.
 	 */
@@ -687,6 +723,12 @@ struct conf_tx_settings {
 	 * Range: CONF_HW_BIT_RATE_* bit mask
 	 */
 	u32 basic_rate_5;
+
+	/*
+	 * TX retry limits for templates
+	 */
+	u8 tmpl_short_retry_limit;
+	u8 tmpl_long_retry_limit;
 };
 
 enum {

drivers/net/wireless/wl12xx/main.c

@@ -116,11 +116,11 @@ static struct conf_drv_settings default_conf = {
 	},
 	.tx = {
 		.tx_energy_detection         = 0,
-		.rc_conf                     = {
+		.sta_rc_conf                 = {
 			.enabled_rates       = 0,
 			.short_retry_limit   = 10,
 			.long_retry_limit    = 10,
-			.aflags              = 0
+			.aflags              = 0,
 		},
 		.ac_conf_count               = 4,
 		.ac_conf                     = {
@@ -153,6 +153,45 @@ static struct conf_drv_settings default_conf = {
 				.tx_op_limit = 1504,
 			},
 		},
+		.ap_rc_conf                  = {
+			[0] = {
+				.enabled_rates = CONF_TX_AP_ENABLED_RATES,
+				.short_retry_limit = 10,
+				.long_retry_limit = 10,
+				.aflags      = 0,
+			},
+			[1] = {
+				.enabled_rates = CONF_TX_AP_ENABLED_RATES,
+				.short_retry_limit = 10,
+				.long_retry_limit = 10,
+				.aflags      = 0,
+			},
+			[2] = {
+				.enabled_rates = CONF_TX_AP_ENABLED_RATES,
+				.short_retry_limit = 10,
+				.long_retry_limit = 10,
+				.aflags      = 0,
+			},
+			[3] = {
+				.enabled_rates = CONF_TX_AP_ENABLED_RATES,
+				.short_retry_limit = 10,
+				.long_retry_limit = 10,
+				.aflags      = 0,
+			},
+		},
+		.ap_mgmt_conf = {
+			.enabled_rates       = CONF_TX_AP_DEFAULT_MGMT_RATES,
+			.short_retry_limit   = 10,
+			.long_retry_limit    = 10,
+			.aflags              = 0,
+		},
+		.ap_bcst_conf = {
+			.enabled_rates       = CONF_HW_BIT_RATE_1MBPS,
+			.short_retry_limit   = 10,
+			.long_retry_limit    = 10,
+			.aflags              = 0,
+		},
+
 		.tid_conf_count = 4,
 		.tid_conf = {
 			[CONF_TX_AC_BE] = {
@@ -193,6 +232,8 @@ static struct conf_drv_settings default_conf = {
 		.tx_compl_threshold          = 4,
 		.basic_rate                  = CONF_HW_BIT_RATE_1MBPS,
 		.basic_rate_5                = CONF_HW_BIT_RATE_6MBPS,
+		.tmpl_short_retry_limit      = 10,
+		.tmpl_long_retry_limit       = 10,
 	},
 	.conn = {
 		.wake_up_event               = CONF_WAKE_UP_EVENT_DTIM,