of/mdio: Fix some endianness problems.

In of_mdiobus_register(), the __be32 *addr variable is dereferenced.
This will not work on little-endian targets.  Also since it is
unsigned, checking for less than zero is redundant.

Fix these two issues.

Signed-off-by: David Daney <ddaney@caviumnetworks.com>
[grant.likely@secretlab.ca: removed goto]
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

drivers/of/of_mdio.c

@@ -52,27 +52,35 @@ int of_mdiobus_register(struct mii_bus *mdio, struct device_node *np)
 
 	/* Loop over the child nodes and register a phy_device for each one */
 	for_each_child_of_node(np, child) {
-		const __be32 *addr;
+		const __be32 *paddr;
+		u32 addr;
 		int len;
 
 		/* A PHY must have a reg property in the range [0-31] */
-		addr = of_get_property(child, "reg", &len);
-		if (!addr || len < sizeof(*addr) || *addr >= 32 || *addr < 0) {
+		paddr = of_get_property(child, "reg", &len);
+		if (!paddr || len < sizeof(*paddr)) {
 			dev_err(&mdio->dev, "%s has invalid PHY address\n",
 				child->full_name);
 			continue;
 		}
 
+		addr = be32_to_cpup(paddr);
+		if (addr >= 32) {
+			dev_err(&mdio->dev, "%s PHY address %i is too large\n",
+				child->full_name, addr);
+			continue;
+		}
+
 		if (mdio->irq) {
-			mdio->irq[*addr] = irq_of_parse_and_map(child, 0);
-			if (!mdio->irq[*addr])
-				mdio->irq[*addr] = PHY_POLL;
+			mdio->irq[addr] = irq_of_parse_and_map(child, 0);
+			if (!mdio->irq[addr])
+				mdio->irq[addr] = PHY_POLL;
 		}
 
-		phy = get_phy_device(mdio, be32_to_cpup(addr));
+		phy = get_phy_device(mdio, addr);
 		if (!phy || IS_ERR(phy)) {
 			dev_err(&mdio->dev, "error probing PHY at address %i\n",
-				*addr);
+				addr);
 			continue;
 		}
 		phy_scan_fixups(phy);
@@ -91,7 +99,7 @@ int of_mdiobus_register(struct mii_bus *mdio, struct device_node *np)
 		}
 
 		dev_dbg(&mdio->dev, "registered phy %s at address %i\n",
-			child->name, *addr);
+			child->name, addr);
 	}
 
 	return 0;